It is not recommended to attempt to bolt to both floor and wall. Set the safe in place and use the holes provided in the bottom or back of the safe to mark the location of the holes to be drilled in the floor or wall. Select a suitable and convenient location for your safe.In this mode, the lock cannot be activated and any key entry will generate an ERROR signal.
The lock automatically enters a two-minute Delay Mode after an invalid code has been entered three consecutive times. NOTE: When changing the batteries, you must use the factory code to open (See back cover.) Passcode will have to be re-programmed. (Note: When the new batteries are installed, the Yellow LED may come ON and stay ON during the first lock operation before it returns to OFF.) (The lock will continue to function in a Low Battery state, until battery failure.) The Yellow LED will turn OFF only after three consecutive “Good Battery” readings or after the low batteries are replaced. If a “low battery” condition is detected, the Yellow LED will come ON and remain ON during each subsequent lock operation. Your electronic lock automatically performs a low battery test during each lock use. Indicates “low battery” and will typically not turn OFF until new alkaline batteries are installed. User Code and remains ON until you have entered a 5-digit passcode. Comes ON in the Program Passcode mode after you have entered your.Comes ON in the Program User Code mode after you enter the Factory Code and remains lit until you have finished entering a 5-digit User Code.Comes ON after you enter a valid code/passcode and remains lit during the 4-second period in which the safe can be opened.After entering each digit of Factory or User Code, or Passcode.You have let 5 seconds or more elapse between key entries.
But if you prefer to use your own code, you can program the safe to open to the 5-digit User Code of your choice. You can always open the safe by entering the 5-digit Factory Code. There are three possible ways to unlock and access the safe-by entering its preset Factory Code, your own User Code or a Passcode. If you pause longer, an error signal will occur (blinking red light and three beeps), indicating you should start over. The lock allows 5 seconds for each key press. A green PROCEED light and a single beep indicate that the keypad “felt” your touch.
(See back cover of this manual for your factory code.)
B) Insert the four batteries as indicated.
Remove key hook plate located on the inside back of the door by sliding the plate upward, then pulling toward you. A) Unlock door with the override key provided in the plastic bag attached to the owner’s manual, and open the door using the lever handle.
To install batteries, remove keypad by rotating the cover counterclockwise, then pulling toward you.